9. Dezember LED-Blinker
Verfasst: 09.12.2018, 10:29
9 LED-Blinker
Hinter dem 9. Türchen findest du einen keramischen Scheibenkondensator mit der Kapazität 100 nF.
Mit dem Kondensator lässt sich ein elektronischer Blinker bauen. Die LED geht in schneller Folge an und aus.
Der Kondensator wird in dieser Schaltung immer wieder geladen und entladen.
Seine Spannung bewegt sich zwischen den beiden Schaltschwellen von 3 V und 6 V.
Die Geschwindigkeit hängt von der Kapazität des Kondensators und dem Ladewiderstand ab.
In diesem Fall beträgt die Zeitkonstante 100 nF mal 2,2 MOhm, also 0,22 Sekunden.
Das entspricht ungefähr einer Schaltperiode des NE555. Die LED blinkt deshalb etwa fünfmal in einer Sekunde.
9 LED blinker
Behind the 9th door, you will find a cramic capacitor with a capacity of 100 nF.
You can build an electric blinker with the capacitor. The LED switcches on and off again in rapid succession.
In this curcuit, the capacitor gets continually charged and discharged.
Its voltage lies between the switching thresholds of 3V and 9V.
The speed is dependent on the capacity of the capacitor and the charging resistor.
In this experiment, the time constant is 100 nF * 2.2 MOhm, so 0.22 seconds.
That's about equal to one cycle of NE555.
Therefore, the LED blinks about five times per second.
Hinter dem 9. Türchen findest du einen keramischen Scheibenkondensator mit der Kapazität 100 nF.
Mit dem Kondensator lässt sich ein elektronischer Blinker bauen. Die LED geht in schneller Folge an und aus.
Der Kondensator wird in dieser Schaltung immer wieder geladen und entladen.
Seine Spannung bewegt sich zwischen den beiden Schaltschwellen von 3 V und 6 V.
Die Geschwindigkeit hängt von der Kapazität des Kondensators und dem Ladewiderstand ab.
In diesem Fall beträgt die Zeitkonstante 100 nF mal 2,2 MOhm, also 0,22 Sekunden.
Das entspricht ungefähr einer Schaltperiode des NE555. Die LED blinkt deshalb etwa fünfmal in einer Sekunde.
9 LED blinker
Behind the 9th door, you will find a cramic capacitor with a capacity of 100 nF.
You can build an electric blinker with the capacitor. The LED switcches on and off again in rapid succession.
In this curcuit, the capacitor gets continually charged and discharged.
Its voltage lies between the switching thresholds of 3V and 9V.
The speed is dependent on the capacity of the capacitor and the charging resistor.
In this experiment, the time constant is 100 nF * 2.2 MOhm, so 0.22 seconds.
That's about equal to one cycle of NE555.
Therefore, the LED blinks about five times per second.