This radio circuit has been adapted to fit easily in the 3D model of the radio kit.
The amplifier circuits needs to be soldered on a small board to ensure quality audio without feedback and noises.
This leaves room for the SW circuit if needed.
It performs really good with clear separation between stations and clear and powerful audio.
The schematic shows LW and MW reception, herefor, I used the coils from the EE series.
The coils MUST be mounted on a separate ferrit rods ( 1 at the front and 1 at the rear ).
You could also use your own coils, but perhaps you need to experiment a bit .
In the next few days, I will post here an audio clip and some details of a PCB around the amplifier.
Greetings
- 47764B56-37B3-47C4-B73C-EA21CBB138A9.jpeg (753.21 KiB) 3404 mal betrachtet
- 47764B56-37B3-47C4-B73C-EA21CBB138A9.jpeg (753.21 KiB) 3404 mal betrachtet